Our BIM content is available as individual families for Revit and templates for both Revit and Fabrication CADmep. The template files contain all pipes and fittings of each specific product line. These can be found on the right side of the screen when accessing the product line’s page.
90º Pipe Trap Adapter H x Slip Joint
Adapters
Create a water tight seal at a 90 degree angle through a Slip Joint connection at the end of this Adapter. Often used in a pedestal sink installation to allow for a trasition from a sink drain tail pipe.
- When tested to the CAN/ULC S102.2 Standard, System XFR achieved a Flame Spread Rating of not greater than 25 and a Smoke Developed Classification of not greater than 50
- Meets National and Provincial Building Codes for high buildings, air plenums, noncombustible construction and penetrating a rate fire separation
- High impact strength in cold temperatures, exceeding CSA requirements
- Improved flow rates
- Lower thermal conductivity can reduce or eliminate the need for insulation
